2390 East 100 South
Columbia City, IN 46725
800.348.2769 | 260.244.4647
www.sailrite.com
Copyright © 2012
adjuSTIng Table heIghT
Screw down the 4 adjustable rubber feet cushions to the feet
of the stand. This will allow you to level the table. Use the nut
to secure the feet at the desirable height (Figure 7).
Use the screws on the sides of the legs to adjust the height of
the table top (Figure 8). Completely unscrew and remove the
hardware and then reattach at desired height, using one set of
the three slots in the legs.
InSTallIng drawer
The drawer should be attached with the table and table stand
remaining upside down. The drawer will mount on the left
underside of the table when upright. Place the drawer in the
desired location, and line up the rails beside it. Make sure that
the drawer will pull out towards the front of the table and that
it does not hang over the edge when pushed back all the way.
Secure the rails to the table with the screws provided, using a
drill to pre-drill holes (Figure 6).
placIng SewIng machIne on Table
If your machine is in its case, lift up the machine and loosen
the two screws (in machine casting) that lock onto the hinge
pins so the machine can be pulled off the hinges easily. You
may need assistance.
Take the hinges provided with your table top and place them
into the rubber bases for the hinges (Figure 9). The hinges
should fight tightly in the bases. Then attach the hinges
directly to the machine casting by tightening the set screws on
the hinge pins.
Once the hinges are attached to the sewing machine head,
insert the machine into the table cut out, guiding the hinges/
rubber bases into the appropriate cut out (Figure 9).
Figure 9
Figure 6
Figure 8
Figure 7
