Chapter 3 Basic Settings Page 25
Power On
To power up the SGT-LD-5-23, follow the steps below:
1.
Plug a user-supplied Cat-5 Ethernet cable from your wired LAN (or a computer) into the power
injector RJ-45 jack (
DATA IN
);
2.
Plug a user-supplied Cat-5 Ethernet cable from the SGT-LD-5-23 into the power injector RJ-45
jack (
P+DATA OUT
);
3.
Connect the power module to the power injector and plug the AC cord into an AC power
receptacle;
4.
After being powered on, the device will send out the beep sound lasting about 1.5 seconds,
informing you that the SGT-LD-5-23 is powered up! Wait about 60 seconds - system will be
initialized and start working.
Figure 18 PoE Connection
Make sure the PoE is correctly connected to the RJ-45 port to the SGT-LD-5-23
labelled PoE+Data, otherwise the SGT-LD-5-23 will be severely damaged!
Warning:
Содержание SGT-LD-5-23
