Specialized in developing,designing and manufacturing kinds of vinyl cutter
6.3 How to use software
6.3-1How use and install Artcut software
，
Please refer to the artcut
instructions.
6.3-2How to use and install Signcut software
，
Please refer to the signcut
software instructions.
6.3-3How to use and install Dradoncut software
，
Please refer to the Dragoncut
software instructions.
6.3-4How to use and install Flexi software
，
Please refer to the Flexi software
instructions.
6.3-5How to use the external program, please refer to the external program
instructions.
6.4Loading media
●Always load media for processing from the rear of the machine.
●Pull the pinch roller level upward to raise the pinch rollers, load your media on
the platen and slide it under the pinch rollers .Move the pinch rollers manually
to the proper position. Be sure the pinch rollers are positioned above the grit
roller.The white marks on top trail will help you position pinch rollers when
media on the platen.push the pinch roller level downward to lower down the
pinch rollers.
●If you are using roll media rather than precut media,use the supplied roll
holder to ensure that the media unrolls smoothly.
●When loading media ,ensure that the media is straight to avoid warping when
transporting the media .A misalignment of just a few millimeters can cause
severe media warp in longer plots.
●You can load the media at any horizontal position in the machine ;it does not
matter whether the media is centered,or aligned on the left or right.
●Fix the pressure rollers by snapping them into place at the outer edges of the
media;this ensures straight feeding of the media and defines the maximum
cutting area.
6.5setting the zero point
The zero point is the point on the loaded media where the plot job will start.You
need to set the zero point whenever you switch the machine on,or after loading
media for processing.
