MorphoAccess® SIGMA Extreme Series - Installation Guide
Identity & Security
Section 3 :Installation Procedure
34
This document and the information therein are the property of
Safran Identity & Security
.
They must not be copied or communicated to a third party without the prior written authorization of Safran
2017_2000024418 - V1
Cabling
Before cabling the product, remove the connector by cutting cables in the middle of
heat shrink tube.
For test purpose, it is possible to use Molex PCB header reference 5016452620.
Figure 10: Cable preparation : connector cut
Cable for wiring shall be AWG 20 to 24, length shall be adapted to the size of the hole
in the wall, to terminal connections, and to the distance between the electric source
and the terminal itself.
Figure 11: Cable preparation : cable position for water tightness
To ensure water tightness, be sure to bend the cable downward.
Closing
Power has to be set up just after closing it. If product has to be stored for a long time
(more than 48 hours), don’t forget to restore its configuration before use.
Finally, lock the product with the screws at the bottom of the terminal.
IP65
!
