Copyright Safewaze 2022
Page 7
LOA
D IN
DICA
TOR
LO
AD
IN
DIC
AT
OR
A
FALL-ARREST
LOA
D IN
DICA
TOR
LO
AD
IN
DIC
AT
OR
A
FALL-ARREST
Option A: Single Leg
Integral Behind the
Web Bracket
Option B: Dual Leg
Integral Behind the
Web Bracket
ANSI Z359.14, ANSI A10.32
OSHA 1910.66, OSHA 1926.502
020047
ANSI Z359.14, ANSI A10.32
OSHA 1910.66, OSHA 1926.502
020047
ANSI Z359.14, ANSI A10.32
OSHA 1910.66, OSHA 1926.502
020047
FIGURE 3 - SRL TO HARNESS CONNECTION EXAMPLES
2.8 LEADING EDGE SRLs
Latitude Edge SRLs have Leading Edge capabilities, and are tested in accordance with ANSI Z359.14 - 2014. Latitude Edge SRLs are tested for
horizontal use and falls over a steel edge without burrs. They have been designed for use in situations where a fall may occur over steel edges.
Use of a Leading Edge SRL requires extra precautions which the user must observe:
• A fall over an edge may require specialized rescue measures.
• The anchor point for Leading Edge SRLs must be situated at the same height, or higher than the edge over which a fall may occur. An
anchor point below the level of the edge is dangerous, as they cause the lifeline to redirect at a sharper than 90-degree angle
(See Figure 4).
• The user(s) must not work on the far side of an opening opposite the Leading Edge SRL anchor point.
• The redirection angle of the lifeline at an edge over which a fall may occur shall be at least 90 degrees (See Figure 4).
• In evaluating your Leading Edge operations, ensure that work parameters are within the Maximum Free Fall Distance, Minimum Setback
Distance, and Minimum Fall Clearance Required in a fall over an edge. These parameters are indicated on the Latitude Edge Labeling.
• Refer to Section 2.0 of this manual for information on the limitations regarding use of this equipment. Work area relative to the anchor point,
swing fall hazards, abrasion of the lifeline constituent on the edge, and a single anchor point, rather than an anchor point that allows
horizontal movement, must all be considered.
FIGURE 4 - ALLOWABLE CABLE REDIRECTION
< 90
˚
≥ 90
˚
OK
NO
AN
SI
Z35
9.1
4,
AN
SI
A1
0.3
2
OS
HA
1
91
0.6
6,
OS
HA
1
92
6.5
02
8
SR
L
’
’
AN
SI
Z35
9.1
4,
AN
SI
A1
0.3
2
OS
HA
1
91
0.6
6,
OSH
A 1
92
6.5
02
8
SR
L
’
’