UAS Installation
36
35
1.
Remove UAS from
Storage Location
Or remove from forward-facing belt path if
UAS was used forward facing.
2.
Route the Connector without
the Adjuster Closest to it
Through the Rear-Facing
Belt Path As Shown
Review your vehicle owner’s manual for UAS belt use and UAS
locations.
Safety Tips
Make sure harness and buckle fit your child correctly before
installing the child restraint. See pages 3-5.
Experts agree that children should remain rear facing as long as
possible. In this child restraint, your child can remain rear facing up
to 18 kg (40 lb) and up to 102 cm (40 in.).
3.
Reach Under Pad and Pull
Connector Across to
Opposite Side
Do not twist belt.
Belt
MUST
be in
front
of buckle strap.
You
MUST
use the 1st or 2nd buckle
slot.
Do not
place belt over child’s legs.
1
2
3
5.
Finished UAS Routing
4.
You MUST Thread UAS Belt
Through Rear-Facing
Belt-Positioning Guides
on Both Sides of Shell
continued on next page
WARNINGS:
Do not use the vehicle lap or lap/shoulder belt
when using the Universal Anchorage System (UAS).
Check UAS belt before each use. Use only if the belt can be
tightened properly and securely.
Do not fasten both UAS connectors on same UAS anchor bar in
the vehicle.
Secure the tether hook when used rear
facing. Attach the tether hook to storage
attachment as shown and gently tighten to
remove slack.
Failure to follow these warnings can result
in serious injury or death.
6.
Fully Recline the Child
Restraint
Pull out on recline handle and push top
of child restraint back.