
Installing Harness System
22
2.
Insert Buckle’s Metal
Retainer into Slot
Closest to Child
Buckle
MUST
face out. You
MUST
use
the 1st or 2nd buckle slots when child
restraint is used rear facing. Any slot
can be used when forward facing.
1.
Fully Recline the Child
Restraint
Pull out on recline handle and push top
of child restraint back.
4.
Check Buckle
Pull up on buckle to make sure it is
secured. The buckle
MUST
not pull
out.
If you have removed the harness straps from the
splitter plate, and the buckle tongues and chest
clip have been unthreaded from the harness
straps, follow the steps below to rethread them.
3.
Reach Under Seat
Between Base and Shell
and Through Recline
Handle
Pull metal retainer completely through
pad and shell.
1
2
3
21
1.
Thread Buckle and
Chest Clip
Harness strap ends go through the
back
of buckle tongues and through
the chest clip
front to back
as
shown.
5.
Adjust the Headrest
to the Highest Position
6.
Undo Fasteners on Seat
and Headrest Pad and
Pull Headrest Pad Off
Bottom of Headrest
Unthread harness straps from slots on
side of headrest.
Loosen harness straps.
Pull chest clip, harness straps, and
buckle tongues out from behind the
headrest and seat pad.
Slide harness straps into slots in
headrest pad and in seat pad.
Attach fasteners.
continued on next page