14
Anchorage fitting installation
FOR CARS FITTED WITH A CHILD
RESTRAINT UPPER ANCHORAGE POINT
Locate the upper anchorage point behind
the rear seating position (consult the car
owner’s handbook for the location of the upper
anchorage point).
Remove the thread plug from the parcel shelf/
floor/roof and install the attachment bolt as
shown in
Figure 1.
CAUTION: DO NOT OVERTIGHTEN THE
ATTACHMENT BOLT. OVERTIGHTENING MAY
FRACTURE OR BREAK BOLT. MAXIMUM
TORQUE IS 20 Nm.
FOR CARS NOT FITTED WITH A CHILD
RESTRAINT UPPER ANCHORAGE POINT
For sedans only
Drill a 9mm diameter hole in the parcel shelf
on the centre-line of the seating position as
shown in
Figure 2. Install the anchor bolt as
shown in
Figure 3. It is recommended that this
installation be carried out by a child restraint
fitting station or licenced motor mechanic.
For vehicles other than sedans
In Australia, consult your nearest child restraint
fitting station or traffic authority for vehicle
inspection to find the best, correct position for
the placement of the upper anchorage point,
and for the correct attachment bolt length and
use of spacers. In New Zealand, consult the
agent for the vehicle.
Vehicle metal
structure
Spacer(s)
(if required)
Attachment bolt
Anchor fitting
Vehicle trim
Vehicle metal
structure
Spacer(s)
(if required)
Attachment bolt
Anchor fitting
Vehicle trim
Lock washer
Nut
Reinforcing
washer
Centre line of
seating position
200mm
min.
FOR SEDANS ONLY:
Front of vehicle
1
2
3
