5
Installing Your Home Connection Monitor System
• To prevent entanglement, only mount the Baby’s Unit in a location where it
and its AC adapter cord are
OUT OF REACH OF CHILDREN.
•
DO NOT
mount the Baby’s Unit directly above heating vents, other heat
producing sources or in direct sunlight.
• To prevent entanglement and overheating,
NEVER
use an extension cord.
WARNING
To Charge the Parent’s Units:
IMPORTANT:
You will need to fully
charge each Parent’s Unit
BEFORE
FIRST USE
and when low battery
indicator is illuminated.
1
.
Unscrew the two screws at the bottom
of each Parent’s Unit. Insert the
Recharging Battery with 2 pin
connector wire facing down. Connect
the two pin connector inside each
Parent’s Unit. Replace the bottom and
secure screws (Figure 1).
2
.
Connect an AC adapter into each
Parent’s Unit and into a power outlet
(Figure 1). It takes approximately 8
hours to fully charge.
1
Recharging
Battery
Screws
NOTE:
The Parent’s Units may use either the AC adapter or the rechargeable batteries
provided.
• When using batteries, check batteries
regularly. Amber LED indicates the
batteries are low.
DO NOT
rely on
Parent’s Unit when batteries are low.
CAUTION
3
. For AC Power Use:
Locate each Parent’s Unit and its AC adapter. Connect the
AC adapter into the side of the Parent’s Unit. Connect the AC adapter into a power
outlet.
CAUTION: DO NOT
use an adapter or batteries that did not come with this
product.
For Battery Use:
Charge the Parent’s Units as noted above.
NOTE:
If desired, slide the belt clip over your belt.
2 Pin
Connector
08038_inst_E_112103 12/10/03 2:01 PM Page 5
