Safeline MX3, Руководство по установке

Страница: 19 / 28

19
© 2015 SafeLine and all the SafeLine products and accessories are copyrighted by law.
MX3 v1.06 EN
Confi guration
OTHER CODES CODE DATA COMMENTS
Compatability mode *77* - #
0 = Automatic voice switching
The call is validated when there is a voice response. The call is
terminated by pressing ”#”.
1 = Kone ECII (lift telephone)
When there is a voice response, some ascending tones will be heard.
The call is validated by pressing ”4”. The call is terminated by pressing
”0”. The call is terminated without reciept notifi cation by pressing ”2”(the
unit will call the next number).
2 = Manual voice switching
When there is a voice response, some ascending tones will be heard.
The call is validated by pressing ”4”. Unit is still in automatic mode.
To enter manual mode and talk press ”
*
”. To listen press ”7”. Go back
to automatic mode press ”4”. The call is terminated by pressing ”#”.
It is possible to enter manual voice switching mode although the unit is
confi gured as automatic by pressing ”
*
”. No ascending tones will be
heard. For repeating the voice message, press “1” in all modes.
3 = Swiss M (Alarm operator mode)
Only to be used in voice mode.
Disconnect by “0”.
Dials the next number if call timeout, blocking tone, new dailing
tone, and operator silence.
Indicator mode *78* - # 0 = Standard
1 = Strictly EN81-28
2 = Strictly single EN81-28
Voice communication time-out *79* - # Value 1 - 20 minutes.
5 = default value
8 = default value for other protocols
Reset active alarm automatically *80* # 0 = Off,
1 = On (Default)
Auto answer *81* - - # No of signals before SafeLine answers incoming call.
Can be set from 00-16 (Default = 02, 00=Unit will not answer).
Unit number *82* - # Unit number [0] is set by default, and means that the unit will respond
immediately.
Unit number [1-9] is used when the units are sharing the same phone
line. When the unit number is assigned, the specifi ed unit is accessible
for programming.
Detect dial tone *83* - # 0 = Off
1 = On (Default)
Set to off if SafeLine has problem to detect the dial tone.
Receipt to alarm receiver with
P100 protocol *84* - # Select which message(s) to send to the alarm receiver at an alarm call.
0 = None (Default)
1 = Start of alarm
2 = Start+end of alarm
Break on new alarm *86* - # Disconnects a call longer than 60 seconds at new activation of the
alarm button and calls the next emergency call number.
0 = Off
1 = On (Default)
Alarm button delay time *87* - - # Delay time from pressing the alarm button until activating the alarm.
00-25 seconds. (Default = 05)