SAFE-TECH SVD-I16, Руководство пользователя

Страница: 10 / 426

CONNECTION AND SETUP
5
2. CONNECTION AND SETUP
Before the DVR is powered on, make sure you have installed a hard disk and connected
at least one camera. For details, please refer to the following sections.
Note:
The DVR is designed to automatically detect the video system of the
connected cameras (NTSC or PAL). To make sure the system detection is
correct, please check if the cameras are connected to the DVR and
power-supplied before the DVR is powered on.
2.1 SATA HDD Installation
A SATA HDD must be installed before the DVR is powered on.
Note:
It’s recommended to clear all data in the hard disk when the DVR is
powered on and the date & time are set correctly to ensure the recorded
data are not mixed with other data previously saved in the same hard disk.
For details, please refer to “5.6.4 Clear All HDD Data” at page 27.
¾
For 16CH & 8CH Models
Step1: Loose the screws on the upper cover and open the upper cover of the DVR.
Note:
The DVR cover is made of metal. Please be careful with its edge when you
remove the cover.
Step2: There are two HDD brackets
for this DVR as indicated on
the right picture.
2-1 To install on the first bracket
Remove the bracket, and align
the screw holes of the bracket
with the HDD’s screw holes. Make
sure the PCB side of the HDD is
facing up.
Fasten the HDD to the bracket,
and connect the power connector
and data bus connector to the
HDD. Then, replace the bracket to
DVR.