We do recommend that you clear any pairing for all the devices before pairing in a group
How to Clear Pairing on the Device(s)?
0
Press and Hold the control / test button. Release the control / test button When the Green Light Have Flashed
4 Times
For AJ interlink series alarms
For the Remote Controller
Press and hold the test button, release the test button when the red light have flashed 4 times
© 2022 - SAFE-TECH | All Right Reserved
1 Short Beep Follow By 1 Long Beep then 1 Short Beep Follow By 1 Long Beep
SAFE-TECH V7
4
After pairing all devices, go back to main device and press the button once to finish pairing.
2
Make sure the alarm is switched on before operation, do not press the button before power on. Wait for 2-3
seconds before starting.
Choose one to be your main device,
press and hold the button, release the button when the
green light has flashed 3 times
. Please take care not to release the button too early!
(If you choose the remote controller to be main device, press and hold the test button. Release the test button
when the red light has flashed 3 times).
One Short beep follow by one long beep then the red light will flash continuously (no sound for the remote control).
3
On other device(s),
press and hold the button, release the button when the green light has
flashed 2 times
. (If you choose the remote controller to be pairing device,
press and hold the test
button. Release the test button when the red light has flashed 2 times
).
One Short beep follow by one long beep then the red light will flash 2 times (no sound for the remote control).
5
Testing: Press the button on any one alarm in a group, all the connected alarms will sound. (Please note –
there may be 3-5 seconds delay before they are all sounding.) The alarm will last for about 10 seconds. You
can manually silence the alarm by pressing the button on each device in turn.
Caution : Loud Beeps
1
How to Switch On Alarms?
*NOTE,
the pairing mode on the main device only stays active for 60 seconds
, if the main
device’s light stops blinking, repeat the process, go back into pairing mode on main device and pair the rest of
the devices to it. If you need to end the pairing mode, press the button once at your main device.
* If you are pairing additional devices to the group,
you only need to use one of the devices
already in
the group to link the new device(s) to the existing group.
*For Pairing Additional Alarms / Remote Controller, Please Start From
2
For Heat Alarm AJ-718i Please Go to Image
A
For Smoke Alarm AJ-762i, AJ-763i Please Go to Image
B
For Carbon Monoxide Alarm AJ-833si Please Go to Image
C
For Remote Controller AJ-R1062 Please Go to Image
D
*Please Pair all devices prior to installing them
Scan for Installation Video
