Page 3
www.safe-t-cover.com 1-800-245-6333
7/14/2020
10.
Insert the Inside Roof Clips into the “D” (roof) panel at the “B#” panel studs (Fig 2C). Using one (1)
hex head screw for each, attach the clips to the “B#” panels as shown.
11.
Repeat Steps 8, 9 and 10 on the other side of the enclosure.
12.
Align the “F” post within the opening utilizing the space between the “C” panels. Install an Inside
Anchoring Bracket (Fig 2B) at the bottom of the “F” post.
13.
Insert an Inside Roof Clip into the “D” (roof) panel at the “F” post stud. Using one (1) hex head screw,
attach the clip to the “F” post (Fig 2C).
14.
Provide a ground-fault interrupter device in all electrical circuits per all applicable codes. Install the
heater(s) as per the manufacturer’s instructions and governing local and national codes.
15.
For maximum protection, it is suggested that the area between the bottom of the enclosure and the
concrete base should be caulked except for the “C” panels. DO NOT CAULK THE BOTTOM OF
THE “C” PANELS.
16.
REMOVE THE PVC MASKING FILM IMMEDIATELY AFTER INSTALLATION. If the panels get
wet with the masking film in place, water will irreversibly stain the panels. Summertime heat will bake
the masking film onto the panels.
CONTENTS
1.
Assembly parts included:
2- “A” (end) Panels
2- “BS” (side) Panels
2- “BL” (side) Panels
2- “C” (access) Panels
1- “Cw/d” (access) Panel
1- “D” (roof) Panel
1- “F” (side) Post
4- Outside Corner Anchoring Brackets (1 ½” x 1 ½”)
5- Inside Anchoring Brackets (3” x 3”)
5- Inside Roof Clips
1- Package of Anchors
1- Package of Hex headed screws
1- Masonry Bit
1- Magnetic Chuck
2.
Tools needed:
A.
Hammer
B.
Drill
C.
¾” Wrench
D.
Hammer Drill
