TROUBLE-SHOOTING GUIDE
Use this chart to trouble-shoot problems with this 35 series Alarm.
PROBLEM
CAUSE/SOLUTION
Green Operational LED Off
1.Bad Wire Connection
2. Reversed Wiring
3. Main Power Off
4. Missing or Blown Fuse
5. Contact Customer Service
No Sound When Testing
Contact Customer Service
No Red LED When Testing
Contact Customer Service
Locked In Alarm
Contact Customer Service
MALFUNCTION ALARM LED 1. Check Battery Voltage
Red/Green & Beeps
Every 15 Seconds
Battery Voltage is Good and it
2. Contact Customer Service
Will Not Reset To Normal operation
END OF LIFE ALARM
Push reset button to reset for
3 days – Replace within 30 days.
Customer Service 800-383-0269 www.safetalert.com
HOW TO TAKE CARE OF YOUR ALARM
This CO / Propane Gas Alarm is designed to be as maintenance free as
possible. To keep your alarm in good working order, you must:
TEST THE ALARM WEEKLY.
See the section,
Test Procedure
,
in this manual for further information.
VACUUM THE DUST OFF THE ALARM COVER.
At least once
a year (more frequently in dusty locations), use the soft brush attachment
of your vacuum to clean the alarm cover.
CLEAN THE ALARM COVER WHEN DIRTY.
Wash the alarm
cover by hand. Use a cloth dampened in clean water. Dry with a soft
cloth
.
DO NOT SPRAY CLEANING AGENTS OR WAXES
DIRECTLY ONTO THE FRONT PANEL.
This action may damage
the sensor, cause an alarm or cause an alarm malfunction.
OBSERVE THE COLOR OF THE INDICATOR LIGHT.
At
frequent intervals and during your weekly test, check the indicator light
on the on the front panel of the alarm.
See the section,
Operation,
in this manual for further information.
PROCEDURES TO TAKE DURING GAS ALARM
1. Turn off all Gas appliances (Stove, Heater, Furnace,
Refrigerator, etc.), extinguish all flames and smoking material.
2. Press the Test/Mute switch. DO NOT DISCONNECT
POWER
3. Evacuate the RV. Make sure everyone is accounted for.
Leave the door and windows open.
4. Turn off the propane tank valve.
5. Determine and repair the source of the leak. Get professional
help if necessary.
CAUTION- DO NOT RE-ENTER UNTIL THE PROBLEM IS
CORRECTED.
PROCEDURES TO TAKE DURING AN CO ALARM
Follow the alarm procedures for your country. The emergency number
depends on your travel location.
Two self-adhesive labels are included with this Alarm. Add the
phone numbers of your emergency service provider and qualified
technician in the space provided. Place one label near the alarm and
one label near a fresh air source where you plan to gather if the
alarm sounds.
PROCEDURES TO TAKE
DURING A CO ALARM IN THE USA
!
WARNING
:
Actuation of this device indicates the
presence of carbon monoxide (CO) or propane gases,
which can KILL YOU. If signal sounds (4 beeps and
flashing
or solid red light):
1)
Operate the Test/Mute
button;
2)
Call your emergency local service (Phone
Number _____________ ) (fire department or 911);
3)
Immediately move to fresh air - outdoors or by an open
door/window. Check that all persons are accounted for. Do
not reenter the premises or move away from the open door
/ window until the emergency responders have arrived, the
premises have been aired out and your alarm remains in its
normal operation.
4)
After following steps 1-3, if your
alarm reactivates within a 24-hour period, repeat steps 1-3
and call a qualified appliance technician. (Phone Number
_______________) to investigate for sources of CO from
fuel burning equipment and appliances, and inspect for
proper operation of this equipment. If problems are
identified during this inspection have the equipment
serviced immediately. Note any combustion
equipment not
inspected by the technician and consult the manufacturers’
instructions, or contact the manufacturer directly, for more
information about CO safety and this equipment. Make
sure that the motor vehicles are not, and have not been,
operating in an attached garage or adjacent to the
residence.
PROCEDURES TO TAKE
DURING A CO ALARM IN CANADA
!
WARNING:
Actuation of this device indicates the
presence of carbon monoxide (CO) and propane gases which
can KILL YOU. If signal sounds (4 beeps and flashing or
solid red light: 1) Operate the Test/Mute. Immediately move
to fresh air - outdoors or by an open door/window. Check
that all persons are accounted for. Do not reenter the
premises or move away from the open door/window until the
emergency responders have arrived, the premises have been
aired out, and your alarm remains in its normal condition; 2)
call your emergency local service (telephone number
_________)
( Fire department or 911).
