Safe Fleet Prime Design PCR-0005, Быстрый старт

Страница: 9 / 16

Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
9
PCR-0005
ASSEMBL
Y INSTR
UCTIONS–RIGHT SIDE RO
TA
TION
Beginning with the Rear
Crossbar, loosen the bolt at the
bottom of the Auto Clamp, then
slide the Auto Clamp toward the inside
end of the Rotation Upper. Reposition
the Auto Clamp leaving a minimum
of 1/4” distance from the rubber
bumper to the edge of the Auto Clamp
Bracket as shown, then finger-tighten if
adjusting later, or torque to 80 in-lbs.
Ensure the Auto Clamp Spring is
seated into the spring catch.
8.3
Place the L Post into
the bottom groove of the
Rear Crossbar, ensuring
the L Post seats into the
Crossbar’s inside bottom
groove as seen from the
front of the Rear Crossbar.
8.2
Prepare the L Post by removing the hex head bolt, lock
washer, flat washer, and Bracket Clamp. Retain for
installation Steps 8.4
-
8.8.
Slide L Post Bracket Clamp
into bottom groove, then slide
into L Post Bracket as shown.
8.4
8.6
Assemble the L Post
hardware. Do not
tighten until Step 8.8.
Bracket Clamp sits
in L Post Bracket
as shown.
8.5
Note: The orientation of
the bolt hole faces away
from the Crossbar.
L POSTS
SEE QUICK START GUIDE FOR ADJUSTMENTS
NOTE: The Auto Clamps may come preset from the factory
for packaging purposes only. To assemble the L Posts to the
Crossbars, the Auto Clamps may need to be repositioned.
8.1