PRIME DESIGN, A SAFE FLEET BRAND
▪
Address: 1689 Oakdale Avenue #102, West St Paul, Minnesota 55118
▪
Phone: 651-552-8554
▪
Toll Free: 1.8.PRIME.RACK
▪
Fax: 651-552-1799
▪
Email: [email protected]
▪
Website: www.primedesign.net
TM & © 2019 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6764268, 6971563, 2364879, 8857689, 8511525, 8991889, 2271515, 2364897, 9506292, 9481313, 9481314, 9796340, 6202807, 6427889, 9415726 AND OTHER PATENTS PENDING
5
Lef
t
Right
Rear
Front
Channel Rear
Channel Front
(A) 96.00”
Flush
Rear
Front
Lef
t
Right
M8 X 20MM
Lock Washer
Flat Washer
Rear
Front
Lef
t
Right
Fig. A
Fig. B
Flush
Push to stop
Fig. B
Fig. A
Apply silicone sealant
(not provided) to screws
Mid Crossbar
Strip Nut
HBR-E-FT43B
ASSEMBL
Y INSTR
UCTIONS–RIGHT SIDE RO
TA
TION
2.6
Position Mounting Brackets to designated dimension shown
below, then torque the M8 X 20MM bolt to 90 in-lbs. Proceed
to Step 3.1.
2.5
Loosen nuts
Position the rear and center
Mounting Brackets as shown.
Position the front Mounting
Brackets as shown.
Attach Mounting Brackets to the Aluminum
Strip Nuts located in the Channels
2.4
2.2
2.3
Torque all M8 x 25MM Flat Head Screws to
150 in-lbs. Apply Silicone Sealant to screw
heads to seal against water intrusion.
The Front Channels include two aluminum Strip Nuts
per Channel for use in a three Crossbar configuration.
For two Crossbar configurations, disregard the rear
Strip Nut in each Front Channel.
Position the Rear
Channel to full stop
as shown in Figure A.
Torque nut to 90 in-lb.
Position the Front
Channel until flush to
End Caps as shown in
Figure B.
Torque all remaining
nuts to 90 in-lb.
Содержание PRIME DESIGN HBR-E-FT43B
Страница 1: ......
