Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
5
FBM-1015
ASSEMBL
Y INSTR
UCTIONS–LR MWB MOUNTING
Channel Rear
Channel Front
M6 x 20MM Bolt
Flat Washer
Sealing Washer
(B) 48.00” ErgoRack
45.00” AluRack
14.00”
(B) 36.00” ErgoRack
30.00” AluRack
(A) 84.00” ErgoRack
75.00” AluRack
Rear
Front
Vehicle
Rear
Vehicle
Front
2.4
Set to distances shown below:
Use Dimensions A for 2 Crossbar models.
Use Dimensions B for 3 Crossbar models.
Do not torque the Crossbar Mounting Brackets until Step 3.4.
Finger-tighten them into designated dimension to hold them in
place, then proceed to your Feature (FEA) Assembly Manual.
Do not mount the Crossbars to this FBM system at this time.
Refer to the respective FEA or AR Assembly Manual(s)
included with your chosen rack configuration features.
Depending upon the features chosen, you may need to
perform a complete feature assembly onto the Crossbars or
Side Rails as noted in that feature’s Assembly Manual.
WARNING: Failure to position the Crossbars as shown in this
FBM Assembly Manual may result in damage to the sliding
door and/or ladder rack.
NOTE:
Crossbars, Side Rails, Base, Clamp Down, or Rotation
features are not included in this FBM kit, and must be
purchased separately. To purchase applicable features and
accessories, please contact your authorized distributor, or a
Prime Design Sales & Service Representative.
3E.1
CROSSBARS
Shown with LH/RH
Rotation for illustrative
purposes only
2.3
Align the channel with the hole pattern on the roof. Install the
fasteners through the factory roof holes as shown then torque
to 60 in-lbs.
Recommended: install the fasteners in the Front of the
channels first and work your way to the back.
