Safe Fleet Prime Design FBM-1012, Руководство пользователя

Страница: 8 / 12

Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
8
FBM-1012
ASSEMBL
Y INSTR
UCTIONS–L2 MOUNTING
3.50” 4.75”
Front Channel
1.50” 1.50”
Rear Channel
Fig. 1
72.00”
Ergo Rack & AluRack
2.25”
Channel Rear Channel Front
Fig. 2
Rear
Front
Lef
t
Right
L2 FBM-1012
1.1
Install Channel Hardware
as shown below.
1.3
Do not mount the Crossbars to this FBM system at this time.
Refer to the respective FEA or AR Assembly Manual(s)
included with your chosen rack configuration features.
Depending upon the features chosen, you may need to
perform a complete feature assembly onto the Crossbars or
Side Rails as noted in that feature’s Assembly Manual.
WARNING: Failure to position the Crossbars as shown in this
FBM Assembly Manual may result in damage to the sliding
door and/or ladder rack.
NOTE: Crossbars, Side Rails, Base, Clamp Down, or Rotation
features are not included in this FBM kit, and must be
purchased separately. To purchase applicable features and
accessories, please contact your authorized distributor, or a
Prime Design Sales & Service Representative.
Foam pad
End Cap
Mounting Plate
Mounting
Bracket
Loosen Bolt
1.2
Install fastening hardware through the Channels as shown
then torque the nuts to 60 in-lbs.
M6 x 30MM Bolt
Flat Washer
Sealing Washer
Fender Washer
Locknut
Channel
Set Mounting Brackets to distances shown in
Fig. 2. Finger-tighten into position–do not torque
until Steps 2.3–2.4.