Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
5
4
2
1
Fig. 1
Fig. 2
M8 x 20mm
Lock Washer
Flat Washer
M8 x 20mm
Lock Washer
Flat Washer
3
DPS-8001 ASSEMBL
Y
INSTR
UCTIONS–ST
OPS AND
HOLDERS
DEPLOY PRO ASSEMBLY SEQUENCE
NOTE: To simplify the assembly and installation process,
it’s recommended to complete the assembly of the Deploy
Pro Ladder rack on the ground or work table, then lift and
place the rack onto the vehicle’s roof.
REAR LADDER STOP ASSEMBLY
Attach the Rear Ladder Stop Brackets to the Top Sliding
Assembly using the hardware shown below. Set both
Brackets flush to the end of the Top Slide shown in
Figure 1. Do not tighten screws until Step 1.3
1.1
1.2
Attach the Rear Ladder Stop Assembly onto the Ladder Stop
Brackets using the hardware shown below. Set the height
shown at Figure 2 between .50”-1.00”. Do not tighten until
Step 1.3.
