Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
6
Fig. 4
Fig. 3
Fig. 5
M8 x 20mm
Lock Washer
Flat Washer
M8 x 20mm
Lock Washer
Flat Washer
Front of Vehicle
Fro
nt o
f Vehicle
DPS-8000 ASSEMBL
Y
INSTR
UCTIONS–ST
OPS AND
HOLDERS
FRONT LADDER STOP ASSEMBLY
Attach the Rear Ladder Stop Assembly onto the Ladder Stop
Brackets using the hardware shown below. Set the height
shown at Figure 5 between .50”-1.00”.
2.2
Torque all bolts
to 90 in-lbs
1.3
2.1
Attach the Front Ladder Stop Brackets to the Top Sliding
Assembly using the hardware shown below. Set the Brackets
flush as shown in Figure 3. Allow a minimum of 3.00” spacing
from the Front Wheel Brackets to the Ladder Stop Brackets
as shown in Figure 4. Do not tighten screws until Step 2.3
Torque all bolts
to 90 in-lbs
2.3
LATCH HANDLE PLATE
3.1
Attach the Latch Handle Plate using four
(4) M8 x 18mm Flat Head Screws.
Torque all bolts
to 70 in-lbs
3.2
