Safe Fleet Prime Design AR1927, Руководство пользователя

Страница: 4 / 8

Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
4
Fig. A
Flush
Rear
Front
Fig. A
Rear
Front
Lef
t
Right
M8 X 20MM
Lock Washer
Flat Washer
Lef
t
Right
Rear
Front
Channel Rear Channel Front
4.50”
72.00”
ErgoRack & AluRack
FBM-1013
ASSEMBL
Y INSTR
UCTIONS–L1H1 CHANNEL MOUNTING
2.4
Set to distances shown below. Do not torque the Crossbar
Mounting Brackets until Step 3.3–3.4. Finger-tighten them into
designated dimension to hold them in place, then proceed to
your Feature (FEA) Assembly Manual.
Do not mount the Crossbars to this FBM system at this time.
Refer to the respective FEA or AR Assembly Manual(s)
included with your chosen rack configuration features.
Depending upon the features chosen, you may need to
perform a complete feature assembly onto the Crossbars or
Side Rails as noted in that feature’s Assembly Manual.
WARNING: Failure to position the Crossbars as shown in this
FBM Assembly Manual may result in damage to the sliding
door and/or ladder rack.
NOTE: Crossbars, Side Rails, Base, Clamp Down, or Rotation
features are not included in this FBM kit, and must be
purchased separately. To purchase applicable features and
accessories, please contact your authorized distributor, or a
Prime Design Sales & Service Representative.
2.3
Install Channel Brackets as shown.
2.2
Position the Channel ends until contacting the
End Caps as shown in Figure A.
Torque all Mounting Bracket Nuts to 90 in-lb.