Fold Here
Installation
1.
Install the mounting assembly (arm and base) in a preferred location. To do so:
i.
Loosen the tamper-resistant nut on the
mounting arm using the tri-groove nut
driver (available for purchase separately),
and then detach the base plates.
ii.
Attach one of the base plates to the
mounting surface of the vehicle using the
supplied self-tapping Torx screws and the
security Torx L-key.
iii.
Reattach the arm to the base plate, and
then lightly tighten the tri-groove tamper-
resistant nut.
2.
Attach the other base plate to the back of
the dock, using the supplied Torx screws and
spring lock washers.
3.
Attach the dock-mounted base plate to the mounting arm, adjust the position of the dock, and
then tighten the tri-groove tamper-resistant nut.
4.
Run the power cable to the source and connect as follows:
• Black wire to ground
• Red wire to vehicle’s battery via the supplied fuse holder, using the supplied butt splice
• Yellow wire to vehicle’s IGN or ACC via the supplied fuse holder, using the supplied butt splice.
5. Connect the GPI harness as follows:
•
Black wire to ground (must be connected)
•
Blue wire to Stop Arm signal, which connects to the flashing red light indicator.
NOTE:
Green, brown, and yellow wires are reserved for future use.
6. Connect the RFID card reader to the dock’s pigtail as follows:
If...
Then...
Using
a serial
reader
1. Connect the RFID harness’s USB connector to the pigtail’s USB port.
2.
Connect the RFID harness’s 2x4 micro-fit connector to the pigtail’s COM 1/2 port.
3. Connect the reader:
•
If using a
micro-fit RFID reader
, connect the RFID harness’s 2x2 micro-fit
connector #1 to the serial reader’s micro-fit connector either directly or via
a supplied serial extension cable.
•
If using a
DB9 RFID reader
(pictured on the diagram), connect the RFID
harness’s 2x2 micro-fit connector #1 to the adapter cable’s 2x2 micro-fit
connector either directly or via a supplied serial extension cable, then
connect the adapter cable’s DB9 connector to the serial reader’s DB9
connector.
NOTE:
The RFID harness’s 2x2 micro-fit connector #2 is reserved for future use.
Towards the dock
Installation diagram
COM 1/2
GPI
Red
3 A fuse
3 A fuse
Yellow
Red: to battery
For future use
Universal USB reader
Serial reader with
a DB9 connector
Yellow: to IGN or ACC
USB
Ground
Green, brown, yellow:
for future use
Blue: to Stop Arm signal
(connects to the flashing red
light indicator)
Ground
(must be
connected)
- OR-
- OR-
#1
#2
NOTE: Choosing a location
Choose a location where the driver will
be able to clearly see the MDT screen.
The MDT should have a clear view of
the sky to ensure the best GPS and
cellular reception.
NOTE: Typical installation
The following instructions describe a
typical installation that includes the
use of the optional mounting arm.
Base plate
Tri-groove nut
Tri-groove
nut driver
1
2
3
4
