CMD1004E Exterior
Dome Camera
Quick Installation Guide
© Seon Design Inc. | 2020 | All rights reserved. Part Number: 700-1031 R2
Installation Kit Contents
•
1 Exterior Dome camera, base, and 4 M4 0.7x 1.0mm screws
•
4 #8x 3/4” Phillips screws
•
1 Torx key
•
1 Quick Installation Guide
•
1 Drilling template
•
1 Base gasket
Choose Camera Location
Determine the location for mounting the camera. Select a flat location
to minimize moisture leakage into the vehicle. Cameras must be
installed with the cabling running inside the wall panels.
Install the Camera Base
1.
Use the supplied Surface Type mounting template to mark the cable
(11/16”) and screw (1/8”) holes on the panel.
2.
Use a step-bit to drill the cable hole, and regular bits for the screw
holes.
3.
Apply the gasket to the camera base.
4.
Pull the camera extension cable from the DVR to the camera
location.
5.
Use the four supplied #8 x 3/4" Phillips screws to install the camera
base to the vehicle surface.
Open the Camera Assembly
1.
Use the supplied Torx key to loosen the screw on the camera bezel.
2.
Unthread the bezel from the camera assembly.
3.
Remove the bezel and the camera dome from the camera assembly.
4.
Connect the 2x3 microfit cable from the camera assembly to the
extension cable.
5.
Pull the connected cabling back into the bus.
Attach the Camera to the Base
Screw the camera assembly to the mounted camera base using the
four supplied M4 0.7x10mm screws.
CAUTION: Vehicle Leakage Risk
For outdoor installations, if a flat surface is not available, seal
the mounting holes under the base of the camera after
installation.
