13
15
16
14
Hold the frame door with position of the upper pin shown in
facing upward. Put the frame door by inserting it to the upper groove
on Top Board (1), then place the lower part aligned into the groove
on bottom board (2).
Repeat this step for the other door. Slide the doors to right and left ensuring
the doors has been placed properly in the provided track.
The unit needs to be secured against wall using tip anti tip kit.
Please Consult your local hardware store to get advice of appropriate screw and fischer
according to your wall type. Drill pre-holes on wall as shown in fig(2) for the tip protector.
Repeat the step with same distance of both tip protector attached in step 15.
Insert fischer to each hole on the wall using hammer.
Secure the Tip Protector (HW22) using Screw M3.5x32mm (HW23).
Make a loop by inserting the provided Fastener / Cable ties into both tip protector on wall
and on backside of product, with the grids surface facing inside of loop.
Fasten the cable ties until position of product as close as possible to wall.
Repeat on the other side.
11
10
Use Wedge (HW10), Screw M 3.5 x15.5 (HW11)
to tighten the back of media stand by using screwdriver.
11
11
X
11
22
Attach Tip Protector (HW22) into back of Top Board using Screw M3.5x15.5.
24
22
23
Grids Surface
