7
XL-DB20014UM-en-US Rev – · 2015-07-29 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Mounting Instructions
7. Install the drawbar (XA-1249-49-10)
into the structure
(Figure 5)
.
9. Install the washer (XB-T-318)
(Figure 6)
.
10. Install the castle nut (XB-T-316-A)
(Figure 7)
.
7.1 Fixed Drawbar Mount
Castle Nut Torque:
Torque to a minimum of 550 ft-lbs.
(746 N•m). Increase the torque an
additional amount, if needed, to align
the hole in the shank of the drawbar
with the castle of the castle nut,
(maximum additional rotation to
be 1/6 of a full turn)
(Figure 8).
7.2 Rotating Drawbar Mount
Castle Nut Torque:
Using only a HOLLAND
®
approved
structure (XA-610-30), torque to a
minimum of 100 ft-lbs. (136 N•m).
Increase the torque an additional
amount, if needed, to align the hole
in the shank of the drawbar with the
castle of the castle nut, (maximum
additional rotation to be 1/6 of a full
turn)
(Figure 8).
Figure 5
Figure 7
Figure 6
Figure 8
XB-1249-49-10
XB-T-318
XB-T-316-A
COTTER PIN HOLE IN SHANK
PROPERLY ALIGNED WITH CASTLE NUT
