English 14 English
Welding GMAW, FCAW-GS, FCAW-SS
Process
DIGISTEP 255C & 305C
can be used to welding GMAW,
FCAW-GS and FCAW-SS process in Manual Mode.
DIGISTEP 255C & 305C
do not include the gun
necessary for GMAW, FCAW-GS or FCAW-SS welding.
Depending on the welding process can be purchased
separately (see "Accessories" chapter).
Preparation the Machine for Welding
GMAW, FCAW-GS and FCAW-SS
Process
Procedure of begin welding of GMAW, FCAW-GS or
FCAW-SS process:
Turn the machine off.
Place the machine conveniently near the work area in
a location to minimize exposure to weld spatter and to
avoid sharp bends in the gun cable.
Determine the wire polarity for the wire to be used.
Consult the wire data for this information. If it is
necessary, change polarity, see [16] point – Terminal
Block of Changing Polarity.
Connect output the gun to GMAW, FCAW-GS or
FCAW-SS process to Euro Socket [6].
Make a sure, if it is needed (GMAW, FCAW-GS
process), that the gas shield has been connected.
Connect the work lead to output socket [7] or [8].
Connect the work lead to the welding piece with the
work clamp.
Install the proper wire.
Install the proper drive roll.
Manually push the wire into the gun’s liner.
Turn the machine on.
Insert the wire into the welding gun.
WARNING
Keep the gun cable as straight as possible when loading
electrode through cable.
WARNING
Never use defected gun.
Check gas flow with Gas Purge Switch [19] – GMAW
and FCAW-GS process.
Close the right side panel.
The welding machine is now ready to weld.
WARNING
The right side panel has to be completely closed during
welding.
WARNING
Keep the gun cable as straight as possible when welding
or loading electrode through cable.
WARNING
Do not kink or pull cable around sharp corners.
By applying the principle of occupational health and
safety at welding, welding can be begun.
Maintenance
WARNING
For any repair operations, modifications or maintenances,
it is recommended to contact the nearest Technical
Service Center or Lincoln Electric. Repairs and
modifications performed by unauthorized service or
personnel will cause, that the manufacturer’s warranty will
become null and void.
Any noticeable damage should be reported immediately
and repaired.
Routine maintenance (everyday)
Check condition of insulation and connections of the
work leads and insulation of power lead. If any
insulation damage exists replace the lead
immediately.
Remove the spatters from the welding gun nozzle.
Spatters could interfere with the shielding gas flow to
the arc.
Check the welding gun condition: replace it, if
necessary.
Check condition and operation of the cooling fan.
Keep clean its airflow slots.
Periodic maintenance (every 200 working hours but at
list once every year)
Perform the routine maintenance and, in addition:
Keep the machine clean. Using a dry (and low
pressure) airflow, remove the dust from the external
case and from the cabinet inside.
If it is required, clean and tighten all weld terminals.
The frequency of the maintenance operations may vary in
accordance with the working environment where the
machine is placed.
WARNING
Do not touch electrically live parts.
WARNING
Before the case of welding machine will be removed, the
welding machine had to be turned off and the power lead
had to be disconnected from mains socket.
WARNING
Mains supply network must be disconnected from the
machine before each maintenance and service. After
each repair, perform proper tests to ensure safety.
