Saeyang Marathon Multi600, Руководство пользователя

Страница: 23 / 40

Error code Status Cause
Motor sensor error
1. Motor hall sensor is troubled.
2. Motor cord is unplugged or defective.
3. Motor cord is broken.
1. Collet chuck is opened.
2. Motor handpiece is troubled.
3. Motor handpiece is electrically broken.
1. Power supply is not in normal condition.
2. The control unit circuit is defective.
1. The unit has been excessively
operated under too high load condition.
2. Motor cord(power cord) is broken or
makes a short circuit.
Motor lock error
Overcurrent
detection error
Overvoltage
detection error
Overheat error
Overdrive error
Self-check error
Internal circuit
error
"1E"
"2E"
"3E"
"4E"
"5E"
"6E"
"7E"
"8E"
1. The motor was vibrated or suddenly
stopped after started in good condition.
1. The control unit interface is troubled.
2. The control unit memory is troubled.
1. The control unit circuit is troubled.
1. The unit has been excessively
operated under too high load condition.
2. The control unit has been exposed to
an excessive hot environment
Check mode Function How to check
Switch
By pressing each of the switches on the panel to turn on individual
LEDs, it is possible to make sure that the unit is in good condition.
Press forward/reverse selector switch ④ to turn on each of the 7
segment LEDs, in order to check that the display is in normal condition.
Values are as much displayed on the 7 segments LEDs in 17 digits(0~9,
A~F) as the foot pedal is pressed. The LED of the hand/foot selector switch
is on by pressing the pedal slightly, but it is off by pressing fully. In doing
so, it is possible to make sure that the foot pedal is in good condition. This
function is released by pressing the forward/reverse selector switch again.
One or two lines are displayed on the 7 segment LEDs by pressing
forward/reverse selector switch ④. Then, one or two lines are turned
on in such manner as one and two lines, one and two lines.............
by manually turning the motor, so as to make sure that the hall
sensor is in normal condition. This function is released by pressing
the forward/reverse switch again.
Display
Hall sensor
Foot pedal
Knee control
panel
Recovery
“Sc”
“dc”
“Hc”
“Fc”
“nc”
“rc”
The maintenance mode is returned to the main mode by pressing
forward/reverse selector switch ④.
By slowly pressing the knee control panel after pushing the forward/reverse
selector switch, values are as much displayed as pressed on the 7 segments
LEDs in 17 digits(0~9, A~F). The LED of the hand/foot selector switch is on
by pressing the pedal slightly, but it is off by pressing fully. In the way, it is
possible to make sure that the foot pedal is normal condition. The function is
released by pressing the forward/ reverse selector switch again.
9. Technical data
9.1 Error code
9.2 Maintenance mode
Beeps are made 2 seconds after turning on the power switch while pressing both
forward/reverse selector switch ④ and motor switch ⑤ at a time, which indicate the
maintenance mode. Turning speed control knob ② makes it possible to change the
maintenance mode to check modes of
“Sc,” “dc,” “Hc,” “Fc,” “nc,”and “rc.”
ENG