Saey PEAK GAS S.C., Инструкция по установке и эксплуатации

Страница: 18 / 23

18
6.2 Switching off the heating
For a short period: turn knob 1 all the way to the right
For a longer period (vacation,…) : turn knob 1 all the way to the right and close the gas supply
6.3 Setting the temperature
Control via thermostat
Set knob 3 of fitting B, to the default position as illustrated. The built-in
thermostat in the gas valve will automatically control the room temperature
as set by knob 1.
The numbers shown indicate the range of the thermostat (1 is the lowest setting, 7 is the highest). It is
only after some time and with regular use that you will discover the correct setting that corresponds to
the temperature you desire. This of course depends on the location, the size of the room, the type of
house and the degree of insulation. Position 3-4 of the control knob should correspond to a 20-22°C.
The size and power of the burner flame will automatically adjust to the requested temperature. As soon
as the room temperature drops below the set limit, the thermostat will switch on, the gas supply will be
opened and the burner will ignite. When the temperature is reset, the burner will only burn at the
minimum and then increase again according to the room temperature.
It is possible that the burner will only burn at minimum on position 3 if the requested room temperature
has just been reached. It may also be that the burner in position 1 will burn at full power when the room
temperature is less than 10°C. In this way, the noise from the ignition is reduced to a minimum. When
the control knob is set to the ignition position, only the main burner will burn and the automatic function
will be switched off. A minimum temperature is then emitted into the room.
If the main burner does not start immediately after a prolonged period of inactivity, be sure
to observe the 60 second interval. Faults which you cannot solve (see chapter "troubleshooting")
must be solved by a technician. To do this, switch off the appliance, close the gas supply and wait for
a technician to arrive on site.