16
Assembly of the smoke duct (optional component) for vertical fume
discharge (ref. 479.0094.000)
First you must remove the round cover plate situated in the upper plate.
In order to do this, the hexagonal bolt (SW 10) that attaches the cover
plate by means of the cast-iron bracket must be removed with a spanner
via the smoke duct on the rear wall. The smoke duct can now be
attached by means of the two hexagonal bolts (M6x20), the 4 pinions
and the two hexagonal nuts (M6) provided. Finally, you must insert your
hand through the opening at the top in order to reattach the round cover
plate to the rear wall and screw it down by means of the cast-iron
bracket and the hexagonal bolts (M6x60) that have also been provided,
as well as the pinions used earlier.
Take note of the following precautionary measures before the smoke
duct is installed :
- the diameter of the smoke duct may not be reduced and it may not be
positioned horizontally, but should still rise towards the chimney at a
slight angle.
- The stovepipe must fit into the chimney opening to make the discharge
of fumes possible. Make provision for a double lining in this regard.
- Chimney connections of different stoves may not be so positioned
opposite one other, i.e. at the same height. This may obstruct the
discharge of exhaust fumes. The distance between two outlets for
fumes should be at least 30 cm.
- Do not connect too many stoves to one chimney – too many
connections hamper the upward draught. Ask your chimneysweeper
for advice.
- The chimney may not conduct any false air. Ensure that the chimney
control valves as well as the cleaning openings in the cellar are closed.
-
The smoke duct must be securely attached to the connector.
3.3 Saey 94 cucina wood
The discharge of fumes
takes place at the back.