Push gently on the edge of the water tank door to release
the hand grip. Remove the tank by pulling the hand grip. To
use without water filter, rinse tank with water. Fill with fresh
water up to MAX mark. Place water tank into machine. To
install water filter see user manual.
NOTE: Only use cool fresh water, any other liquid may cause
damage.
Remove coffee bean hopper lid. Slowly pour beans into
hopper. Replace lid.
NOTE: Only use coffee beans. Ground, instant and flavored
coffees may damage the machine.
QUICK START GUIDE
MOLTIO FOCUS
HD8767/47
PLEASE NOTE: OUR MACHINES ARE TESTED WITH
COFFEE AT THE FACTORY TO ENSURE HIGH
QUALITY STANDARDS. WHILE MACHINES ARE
CLEANED THOROUGHLY AFTER TESTING, IN
SOME CASES, COFFEE GROUNDS MAY REMAIN IN
THE MACHINE.
FOR FULL INSTRUCTIONS, PLEASE REFER TO THE
USER MANUAL
1
BEFORE FIRST USE
2
Switch power button on back of machine to the “I” or ON position.
Turn machine on by pressing “ ” button on control panel.
2
1
SET UP
CONTROL PANEL QUICK REFERENCE
For a full understanding of functions, see the user manual.
24. Espresso brew button
25. Coffee brew button
26. Steam / hot water button
27. "Aroma" - Pre-ground coffee button
28. "MENU" button
29. ON/OFF button
TROUBLE SHOOTING
Q: Why isn’t my coffee coming out hot enough?
A: Cups may be cold. Preheat cups with hot water prior to dispensing coffee.
Q: Why is my coffee coming out so weak?
A: The machine automatically adjusts itself after brewing a few cups of coffee to
optimize the extraction of the coffee to the compactness of the ground coffee.
We recommend brewing 3-5 espressos before drinking to allow for this
adjustment process. Refer to the "Saeco Adapting System" in the user manual
for more information.
A: The coffee may be too coarse. Change the coffee blend or adjust the grind.
Finer coffee grounds result in stronger tasting coffee. Refer to the “Adjusting
the ceramic coffee grinder” in the user manual for more information.
Q: Why is my machine leaking water/coffee?
A: Sometimes water is drained automatically by the machine into the drip
tray to manage the rinsing of the circuits and ensure optimum machine
performance.
A: The dispensing spout may be clogged. Clean the holes in the dispensing spout.
Q: Why isn’t the machine filling up my cup?
A: The machine’s coffee lengths can be programmed. Enter the beverage
programming menu and adjust the coffee length setting to your liking for
every beverage. See "Adjusting the coffee length" section in the user manual.
For more troubleshooting please refer to the User Manual.
NEED ASSISTANCE:
If you have any questions or concerns, we are always available to
assist you.
Please call us direct at 1-800-933-7876 or visit us at
www.philips.com/saeco
6.1.2015
421946031661
26
29
24
27
25
28
3
Once machine turns on, it will indicate a priming cycle
must be started. Place a container under the steam wand.
421946031661_MoltioFocus_HD8767_47_.indd 1
9/10/15 3:52 PM
