Saeco Incanto Classic, Руководство по обслуживанию

Страница: 137 / 224

INCANTO 3. OPERATION
Saeco International Group REV.5 FEB.2005 Page 11/16
Troubleshooting
Fault/Indicator Possible cause Remedy
Machine does not function No power Check mains plug / mains
circuit breaker
Ensure machine door is closed
BREWING UNIT NOT
DETECTED Brewing unit not properly installed
or not closed Install brewing unit correctly
GRINDS CONTAINER NOT
DETECTED
Coffee grinds container not properly
installed Brewing unit correctly
installed
EMPTY GRINDS
CONTAINER Coffee grinds container full Empty coffee grinds container
(reset only possible if machine
is turned on)
COFFEE BEAN
CONTAINER EMPTY
Coffee bean container is empty Fill coffee container
FILL WATER
DE-AERATE Water tank is empty Water tank
GRINDER OBSTRUCTED Clean grinder
DE-AERATE Air in water system Open water nozzle
Instead of coffee, only water is
dispensed Coffee powder selection button is
pressed, but no coffee powder is
dispensed Add one level measure of
coffee powder
No water / steam Steam nozzle blocked Free opening using a thin
needle
The coffee flows too quickly Beans ground too coarsely Select lower grinding level;
e.g. change from 8 to 6
The coffee flows too slowly Beans ground too finely Select higher grinding level;
e.g. change from 8 to 10
The cups are cold Pre-heat cups Coffee is not hot enough
Boiler temperature too low Increase temperature in user
programme
Unsuitable coffee blend Change brand of coffee
Coffee is no longer freshly roasted Use fresh coffee
Coffee has no froth
Beans ground too coarsely or finely Change grinding level
Longer heating time or less hot
water The machine is calcified Decalcify machine
The brewing unit cannot be
removed
The brewing unit is not in home
position Turn machine on, close
service door and check dregs
drawer
(the brewing unit goes
automatically to home
position)