Saeco GrabBaristo HD8964, Руководство пользователя

Страница: 82 / 92

80
ENGLISH
Machine actions Causes Solutions
Milk does not froth. The milk dispensing spout has not
been pulled out Check that the milk dispensing spout has
been pulled out correctly up to the “
” icon
The carafe has not been correctly
reassembled or with all its compo-
nents. Make sure the wand is correctly inserted.
All its components have to be correctly
reassembled, as described in the “Weekly
cleaning of the Milk Carafe” section.
The machine takes a long
time to warm up or the
amount of water dispensed
from the wand is too little. The machine circuit is clogged by
limescale. Descale the machine.
The brew group cannot be
removed. The brew group is out of place. Turn the machine on. Close the service
door. The brew group automatically
returns to the initial position.
The coff ee grounds drawer is
inserted. Remove the coff ee grounds drawer
before removing the brew group.
There is too much ground
coff ee under or over the
brew group. The coff ee used may not be suitable
for automatic machines. It may be necessary to change the type of
coff ee or the coff ee grinder settings (see
“Adjusting the Ceramic Coff ee Grinder”
chapter).
The machine is adjusting the coff ee
grinder for a new kind of coff ee
beans or pre-ground coff ee. The machine automatically adjusts itself
after brewing several cups of coff ee to
optimise the extraction in relation to the
compactness of the ground coff ee.
It may be necessary to brew 2 or 3
products for the coff ee grinder to adjust
completely.
This is not a malfunction of the machine.
The machine produces too
humid or too dry coff ee
grounds. Adjust the coff ee grinder. Adjusting the ceramic coff ee grinder af-
fects the quality of residues.
If the residues are too humid, set a coarser
grind.
If the residues are too dry, set a fi ner
grind.
Refer to the “Adjusting the Ceramic Coff ee
Grinder” chapter.
The machine grinds the
coff ee beans but no coff ee
is brewed (see note). There is no water. Fill the water tank and prime the circuit
(see the "Manual Rinse Cycle" chapter).
The brew group is dirty. Clean the brew group (see the "Weekly
Cleaning of the Brew Group" chapter).
This might occur when the machine
is automatically adjusting the dose. Brew a few coff ees as described in chap-
ter “Saeco Adapting System”.
The dispensing spout is dirty. Clean the dispensing spout.