Setup Instructions
1.Pair door sensor(s) with receiver:
Please do the following steps as soon as possible since receiver will exit learning
mode automatically if it doesn't get signal from transmitter in 5 seconds. In order
to avoid interference, pair 1 transmitter only at any given time.
a) Select desired ring tone by pressing music control button
b) Set receiver into learning mode (pairing mode) by either method i) or method
ii) below. A chime and LED flashing will indicate the ready status.
i) Press the Volume and Music control buttons on the receiver
simultaneously.
ii) Or press the Volume control button on receiver for 5 seconds.
c) Pair transmitter with receiver by separating the two parts of door sensor to
trigger it until you see the indicator light up and hear the tune you selected, which
means that your operation is completed successfully.
2.Add additional receivers or sensors
Repeat steps a-b-c above to add more receivers or sensors. Supports 10
transmitters at most.
3.Reset
To reset all settings, press the music control button for 5 seconds, then pairing
will be relieved and tune turns into the default music–Ding Dong. You can trigger
transmitter to verify default ring tone—Ding Dong.
______________________________ 4 _______________________________
