For Full Control
Select the new parameter values and click OK to
save changes to the receiver.
Editing Transmitter Parameters:
The easiest and most intuitive way to set the parameters of SACOM
™
transmitters and receivers is with SACOM
™
Remote
software. Load SACOM
™
Remote (from disk or download from www.SacomUSA.com) onto a computer running Windows
XP or Windows 7 (32 or 64-bit) and connect to the receiver via USB or RS232. Then open SACOM
™
Remote and select
ONLINE.
Open The Channel Edit Window:
1) The [Click to Edit] function opens the edit window of the channel you wish to edit.
2) Select the functions you want to edit and enter the parameter. (
The various functions are described below.)
Click [OK]
to save the changes and close the Channel Edit window.
3) You will notice that the [Needs to Sync] alert is lit. This indicates that one or more parameters are in queue in the receiver
ready to be downloaded and implemented with the next transmitter Sync of the channel.
1)
2)
Digital Wireless Microphone Systems
Using the SACOM remote software:
Click to Edit the channel’s parameters
3)
The “Need To Sync” alert is lit. Sync the transmitter to apply the selected
parameters.
SACOM Remote provides the following functions:
File:
1.
Save a PDF image of the screen.
Settings:
2.
Phantom Power:
A.
Turn antenna phantom power
on
or off. Default = ON.
Redundancy:
B.
Set adjacent pairs of receivers to redundancy mode. Default = OFF.
Headphone Mode:
C.
Toggles the mixed output jack from headphone mode to a balanced line output. Default = Balanced
line output.
Ethernet Settings:
3.
If using Ethernet, assign the proper IP address to the Sacom Receiver.
RF Scan - RF Plot:
4.
Shows the RF strength of each antenna in a SACOM system and shows if there is outside interference.
Presets:
5.
Save or load preset system parameters configurations. Default = As Ordered.
GPIO:
6.
Assign contact closure functions and setup for RS232 control. Default = RS232 - Output mutes.
Security:
7.
Password to prevent unauthorized changes: (Under construction). Default = none.
Alerts:
8.
Send alerts to authorized personal when preventive maintenance is required of if there is a fault. Default = none.
Update System:
9.
Checks to see if the system has the most current firmware and provides a wizard for updating the firmware.
Help:
10.
Tutorials:
A.
Setting parameters, Antenna Application Guide, etc.
About:
B.
Shows vital statistics for each component of the system
SABINE INC.
l
13301 NW US Highway 441
l
Alachua, Florida 32615-8544 USA
l
Phone: +USA (386) 418-2000
l
Fax: +USA (386) 418-2001
l
www.SacomUSA.com
Trans Last 4 digits of serial Number Default Transmitter Preamp Gain
BLT XXXX
10 dB
HH XXXX
H18 = 0dB / H10 = 10dB
PDM XXXX
10dB
BDM XXXX
20dB
Default Transmitter Preamp Gain Settings:
BLT = Beltpack
HH = Handheld Mic
PDM = Podium Mic
BDM = Boundary Mic
Key:
