w w w . c l a s s i c
e x h i b i t s . c o m
Step 2
Page 2 of 2
866.652.2100
© 2012
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #xxxxx - Sacagawea - Attachments
Slide A10 Clamp
into groove
of square extrusion.
When desired location
is found, tighten
set screw to secure.
Set-
Screw
A10
Tighten black plastic
set screw to secure
Wing in place.
Black Plastic
Knob
Wing Attachment
Keep A10 clamps
attached to verticals
Graphic
Screw
Cap
Standoff
Barrel
Slide connector on back of standoff
barrel into groove of extrusion
and twist to secure in place. Secure graphic
to standoffs using screw cap.
Graphic Attachment
7
8
9
Note:
Curved extrusion
[10] and horizontal [11]
stay assembled for
shipping and packing.
10
10a
11
Screw
11a
Counter Top Attachment
Insert screws located on underside
of counter into holes on flange plate
and secure with wing nuts.
Wing Nut
Attach graphic
to
velcro
on back of
header frame
Item
7/8/9
10
10a
11
11a
Description
Header Frame
30.2” Curved Extrusion
Leg Support
12.184”w Horizontal Extrusion
Flange Plate
Qty.
2/2/2
1
1
1
1
Note
: Header frame ships
and packs assembled
Steps:
1) Attach lights as indicated.
2) Attach assembled header frames and apply graphics as shown.
3) Attach assembled counter support [10/11] to verticals where indicated.
4) Attach support leg [10a] to counter supports [10/11].
5) Attach flange plate [11a] to top of curved extrusion [10] as shown.
6) Attach counter top to support, see
counter top attachment
detail.
7) Attach wings to A10 clamps as shown.
8) Attach round signs to backwall frame as indicated.
9) Attach monitor mount to backwall with screws as shown
7
8
9
Attach graphic
to
velcro
on back of
header frame
*
*
*
*
*
Light Connection
Attach lights to
backwall where
desired and
tighten in place.
Connector
Monitor
Mount
