SAC UMAC S24.0, Инструкция по эксплуатации

Страница: 5 / 24

Professional Amplifier
5
Front Panel and functions
[Front Panel]
S24.0
S8.4
S2.5
1. PWR
2. STBY
3. S/C/P
4. B
1 3 4 2
1 3 4 2
1 3 2
If the Switch of the rear panel is ON, the blue LED will light up and AMP will enter the operating state.
If the Switch on the rear panel is OFF and the AC Cord is connected, the red LED lights up and the AMP go into standby mode.
When the AMP is normal output, the green LED lights up and when it is in Clip or Protection state, the orange LED lights up.
S : If AMP is normal output, the brightness of LED will be different according to output level.
C : This LED indicates the distortion of the output sound. If AMP output is distorted due to the input of the AMP, the
Orange LED will be on for the duration of the interval.
P : If an error occurs in the unit due to overheating or other problems, the orange LED will remain lit and the output
signal to the speaker will be cut off.
It is the LED displayed Bridged Mono Mode. When the Bridge Switch on the Rear panel is ON, the orange LEDs of the
corresponding two channels are turned on.
(S24.0 and S8.4 Only)
※ S24.0 : Bridged Mono Mode is No.3+4CH, No.5+6CH.
S8.4 : Bridged Mono Mode is No.1+2CH, No.3+4CH, No.5+6CH and No.7+8CH.