Page # 21
•
It is extremely important that the following lubrication schedule be followed:
Bearings: use a good quality
multipurpose grease. Replace all damaged or missing grease zerks immediately. Always clean zerks before using
grease gun. Pump the grease in slowly until a slight bead forms around the bearing seals. Once a month check lines
and connections on grease banks for leaks.
• Oilbath
Oil:
Use a high good quality universal oil. Use an oil that meets or exceeds hydraulic oil grade. Fill to the top
lower oilbath roller chains. Change yearly or whenever contaminated.
•
Before operating a new mixer,
the roller chains should be liberally lubricated and then the unit operated under a
no-load condition. This break-in period will allow the roller chains to be thoroughly lubricated and thus minimize
heat-up during operation.
LUBRICATION
LUBRICATION
ITEM LUBRICATION
INTERVAL
CAPACITY
OIL TYPE
LOCATION
1
8 HOURS
HIGH QUALITY MULTI PURPOSE GREASE
FRONT AUGER & REEL BEARINGS
2
8 HOURS
REAR AUGER & REEL BEARINGS
3
8 HOURS
DRIVELINE UNIVERSAL JOINTS
4
50 HOURS
APPROX. 3.5 GALLONS
GOOD QUALITY HYDRAULIC OIL
OIL BATH OIL (CHECK LEVEL)
REPLACE ANNUALLY
5
ANNUALLY
APPROX. 2 GALLONS
DEXTRON III OIL
SLIDE TRAY POWER UNIT
6
ANNUALLY
1.5 PINTS
80W90 GEARLUBE
2:1 GEARBOX
Содержание TURBO-MAX 6141
Страница 25: ...Page 25 READ complete manual CAREFULLY 25 MON900728 2 3 6141 BASE BOX ASSEMBLY ...
Страница 62: ......
