
33
B2-SWM-Op-Guide-v4.pmd 030108-hto
Section Eleven : Appendices
Refer to Section 6.5 How to Set Up the
FBX Section of Your True Mobility Sys-
tem for a description of Fixed versus Dy-
namic FBX Filters.
1. Remove receiver top cover
Take out four screws on each side and
two from the top of the back panel. Sort
and save all screws. Lift the back of
the top cover, and then pull until the
edge of the top cover (and three tabs)
emerge from under the front panel plas-
tic rim.
2. Change DIP switch settings
There are two PC boards inside the receiver. With the front of the unit facing you, the left and smaller
board (Figure 11a) has a DIP switch in the middle of the right hand side. The DIP switch is covered with
a translucent piece of yellow plastic wrap. Pull off the wrap (it cannot be reused). Note that there are five
switches. One side of the DIP switch is clearly marked ON. The factory default setting is with all switches
set to ON (see Figure 11b).
Refer to Figure 11c to set the number of Fixed and Dynamic filters to 8 Fixed and 2 Dynamic and Figure
11d to widen the filter width to .20 (1/5) octave. These options can be combined to produce 8 Fixed and
2 Dynamic 1/5-octave filters by pushing switch numbers 1 and 2 to the OFF position (Figure 11e). Refer
to Section 6.5 for a complete understanding of these options.
3. Replace top cover
Align and insert the three front tabs under the front panel plastic rim, then lower the back of the cover.
Replace all screws. DO NOT FORCE screws. If they do not go in easily, adjust cover alignment and try
again.
SECTION ELEVEN : APPENDICES
11.1 FBX Configuration DIP Switch
WARNING: Do not change switch 3, 4 or 5 from the default ON setting!
WARNING: ELECTRIC SHOCK HAZARD! UNPLUG receiver BEFORE taking off top cover! Seri-
ous injury or death may result if unit is opened/worked on while plugged in. These proce-
dures are to be performed by qualified personnel only.
Figure 11a - FBX Configuration DIP Switch
DIP Switch
Front of box
Figure 11b
Default setting
7 Fixed, 3 Dynamic
One-tenth Octave
Number of Fixed/
Dynamic filters
FBX filter width
DO NOT
CHANGE
Figure 11d
Wider FBX filters
7 Fixed, 3 Dynamic
One-fifth Octave,
More Fixed filters
8 Fixed, 2 Dynamic,
One-tenth Octave
Figure 11c
Both
8 Fixed, 2 Dynamic,
One-fifth Octave
Figure 11e
Содержание True Mobility SWM1600
Страница 2: ......