550 [MH110]:
Insert 1 flat head screw M6x20mm in each hole
•
without tightening.
Proceed to tighten the screws.
•
558 [MH117]:
Insert 1 flat head screw M6x16mm in the rear
•
hole and 1 M6x20mm in the front ones.
Proceed to tighten the screws.
•
590/695 [MH118]:
Insert 1 flat head screw M6x25mm in the central
•
hole and 1 M6x20mm in the rear and front hole.
Proceed to tighten the screws.
•
718 [MH109]:
Insert 1 flat head screw M6x25mm in each hole
•
without tightening.
Proceed to tighten the screws.
•
Board connection:
Insert the proper screws for the board from the upper side.
•
Check that all screws are inside the bushing before tightening.
Proceed to tighten the screws.
•
Lithium grease
[MHW033]
Front wing screws:
kite foil manual
1
2
Match the fuselage [MH112]:
Insert 1 socket head screw M6x20mm and 1 washers 6.2x 9.9 x 1mm
•
in each hole without tightening.
Proceed to tighten the screws.
•
Always keep the threaded holes and every connection between carbon
(mast and wings) and aluminum (fuselage) clean and greased with
"lithium grease" [MHW033] to avoid and prevent oxidation and corrosion
due to salt water.
Stabilizers screws [MH107]:
Insert 1 flat head screw M6x16mm in
•
each hole without tightening.
Proceed to tighten the screws.
•
Check the latest version of this manual
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 N
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 Nm
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 N
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 Nm
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 Nm
