Sabaj Premium K Series, Руководство пользователя, Страница: 12 / 13

www.rtv.sabaj.pl
12
RF Remote Control assignment
The supplied RF remote is already programmed with your TV-Lift . In case you want to program a new one , follow these steps :
-
Press& hold the RC Set button for about 3 seconds
- The lift will wait for any signal from a remote for 15 seconds from now on
- Press any button on your remote
- The lift will acknowledge the new remote , which will now be operative
Note : The Control Box has a memory of 8 Remotes. If you will want to program the 9
th
remote control – the 1
st
will be
deleted
POWER GUARD (Standby mode detection)
If you will plug your TV in to The control box socket – it will monitor the energy consumption of your screen. If the user
attempts to hide the fully operating screen (turned ON), the control box cuts the power out. After lifting the screen back to the
viewing position, the power will be restored to it. If the TV is turned off or in standby mode, the power will not be cut out.
Safety system operation
The intelligent safety system detects the obstacles when the screen is moving down as a weight difference. It does not require
any calibration, which is done automatically. After detecting an obstacle the lift stops, and moves up about 5 centimeters. The
safety system works only during the down movement. When the safety system is activated, the blinking “1” appears on the
display.
Active RJ-45 Socket
Your Premium Control box is equipped with the active RJ-45 Socket , which allows to plug additional accessories
supplied by SABAJGROUP. NOTE: Only the original SABAJGORUP accessories will work with your Premium Control
Box. If you attempt to modify or connect any other devices via the RJ-45 Port, you might damage the Control Box and
you will loose the warranty for doing so.
Display messages:
The numeric display shows the information about the lift operation. If the display shows :

“0” Blinking - electric motor overload (current exceeded)

“1” Blinking – safety system has been triggered

“2” Blinking – power cut out when hiding the active screen

“3” Blinking - wiring loom not connected to the control box

“4” Blinking - lower limit switch activated

“5” Blinking – upper limit switch activated Pressing any
button will delete the display message.