SAB Goblin black thunder, Инструкция по эксплуатации

Страница: 29 / 44

CANOPY
Install the canopy following these step :
- Canopy edge protection, Adhesive foam tape, Canopy grommets. (Fig.6)(Fig.7).
The canopy hole must be 12.5 mm in diameter. Initially is 9 mm.
You can enlarge the hole slightly to optimize the vertical position of the canopy itself.
Install the quick release following Fig 9 . Use special tool inside the bag.
To install the canopy:
- Insert the canopy from the front up to the area of the block shown in Fig.8 .
- Use the quick release canopy mounts to properly mount the canopy.
It is recommended a bit of lubricant on the quick release canopy mount system.
TAIL BELT TENSION
*Check the proper assembly of the tail boom.
*Check that the aluminum part of the tube is against the M3 stop screw.
*Loosen the tail group by loosening the 4 M3 screws.
*Install the belt onto the pulley, taking care to respect the direction of rotation ( figure 1 ).
*Rotate the tail drive several times by hand.
*Load the spring by a rotation of 270° the tensioning arm ( clockwise ).
*Tension the boom until the tensioning arm is aligned with the frame.
*Tighten the 4 screws.
*Check that the tail output shaft is perpendicular to the tube. ( figure 2 )
*In figure 3,4,5 you can see the three conditions, ok, too loose and too tight.
NOTE . To disassemble the tail boom, you can remove the front pulley (H0172-S)
without loosening the tail box. Simply remove the bolt and pull down.
Bag 21
[HA111]
Page 27
Chapter 13,Installation Of the Boom and Canopy