SAB Heli Division Goblin 570 Sport, Руководство пользователя, Страница: 25 / 36

0.75mm
90°
Nylon Screw M8x14mm
(HC164-S)
Boom Bolt Safety lock
(H0287-S)
Installation Of The Boom
- Insert the boom in place helping enlarging the frame ( Fig 1,2 ).
- Push the boom forward until the nylon bolts bottom out against the end of
the slot on the boom.
- Tighten the nylon bolts and only after tighten the two M3x10mm screws.
- For additional safety, install the boom bolt safety lock (Fig 1).
Tail Belt Tension
- Make sure the boom is assembled and installed correctly.
- Loosen up the tail case by loosening the 4 M3 screws.
- Mount the tail belt on the front pulley making sure the direction of rotation is correct (Fig 3).
- Rotate the tail drive several times by hand.
- Load the spring by a rotation of 180° the tensioning arm
- Adjust the belt tension by pulling on the tail case until the tensioning arm is aligned with the frame (Fig 4).
- Tighten the 4 M3 screws.
- Check that the tail output shaft is perpendicular to the boom (Fig 5).
- Connect the tail push rod to the tail servo.
- Make sure the tail belt and carbon rod are free, check the belt to ensure it is not twisted.
NOTE: To remove the tail boom from the helicopter, it is possible to remove the front tail pulley
H0304-S without having to loosen up the tail case. Simply remove the locking screw and pull.
Note: Between the boom and the aluminum
plate, there is a space of around 0.75mm.
Look the picture.
Socket Head Cap
Screw M3x10mm
(HC056-S)
Washer
3.1x 12x1.8mm
[H0078]
Bag 7.12
Socket Head Cap
Screws M2.5x6mm
(HC018-S)
[H0287]
Page 23
Chapter 13, Installation of the Boom