TOOLS AND ADHESIVES
*Drill with drill bits 2, 3, 4, 5mm.
*Small milling cutter for drill.
*Generic pliers.
*Hexagonal driver, size 1.5, 2, 2.5, 3 mm.
*Cyano-acrylate glue.
*Epoxy glue.
*Medium threadlocker (eg. Loctite 243).
*Soldering equipment (for electric wiring).
ADDITIONAL COMPONENTS REQUIRED
* Turbine from 12kg to 22kg. (with Accessories).
* Landing gear system.
* UAT.
* Batteries.
* Radio power system.
* 2 Wings servos (20x40 mm standard size, min. 20 KG).
(In case you want to have separate aileron/elevator it need 4 servos)
* 2 Vector servos (20x40 mm standard size, min. 30 KG).
* 2 Rudders servos (15x35 mm mini size, min. 6 KG).
* 2 Canard servo (20x40 mm standard size, suggested 30 KG).
* 1 Steering system servo (20x40 mm standard size, min. 10 KG).
* 3 Doors servos (12x23 mm micro size).
* Accessories, extensions, tubes.
The assembly process is described in the following chapters. Each chapter provides you with the bag number you will need for that chapter. The information is printed in a red box in the upper right
corner of the page at the beginning of every chapter.
Sand and fit where
necessary
Use CA Glue
Use Epoxy Glue
Use Thread Locker
Medium Strength
( SAB HA116-S)
NOTES FOR ASSEMBLY
Please refer to this manual for assembly instructions for this model. Follow the order of assembly indicated. The instructions are divided into chapters, which are structured in a way that each
step is based on the work done in the previous step. Changing the order of assembly may result in additional or unnecessary steps.
Use thread lockers and retaining compounds as indicated. In general, each bolt or screw that engages with a metal part requires thread lock.
It is necessary to pay attention to the symbols listed below:
BAGxx
Indicates that for this assembly
phase you need materials that are:
BAG xxx.
Important
Page 3
NOTES FOR ASSEMBLY
