-back lighting defaults
back to green
Problem
Possible Cause
Solution
Troubleshooting:
-gauge not reading
-bad connection on gauge
-test for power at the back of the gauge
-no back lighting
-incorrect wiring
-connected to a dimmer
-refer to fitting instructions
-refer to fitting instructions
-back lighting stuck
on white
-incorrect wiring
-connect or check orange wire for 12V+
-incorrect wiring
-check orange wire for 12V+
-battery was disconnected
-press button to set desired colour
Please note:
If you are having problems with the installation of this product, please do not
contact your retailer or SAAS until you have read
ALL
the troubleshooting notes below.
-wrong signal wire
-check oxygen sensor diagrams for
correct application
Total depth of gauge
Gauge operating range
Specifications
GAUGE INFORMATION
Gauge lighting type
Mounting depth required for gauge
4 colour LED (NON DIMMABLE)
50mm (minimum)
55mm (including bezel)
Mounting hole size for gauge
52mm
Gauge lighting colours
green > red > blue > white (default colour green)
0.00mV > 1.0V
Gauge operating voltage
8v > 18v
Page 3/3
Gauge sensor input type
narrow band only!
Contents:
In The Box
Qty
Air/Fuel gauge
Wiring connector
Mounting U bracket
Mounting U bracket studs (M4x0.7 thread)
Mounting U bracket nuts
Mounting U bracket spring washers
Fitting instructions
1
1
2
2
2
Notes
1
SG31005
Part No.
1
SG3130
Warranty Terms & Conditions:
SAAS Automotive Pty Ltd warrants this product against defects in factory workmanship and
materials for a period of twelve (
12
) months from the date of original purchase. This warranty
applies to the first retail purchaser, is non-transferable and covers only where the product has
been subjected to normal use or service. Provision of this warranty shall not apply to any SAAS
Automotive product that has been used for a purpose for which it is not designed, or which has
been altered in any way that would be detrimental to the performance or life of the product, or
misapplication, misuse, negligence or accident. Warranty claims to the manufacturer must be
transportation prepaid and accompanied with dated proof of purchase. On any part or product
found to be defective after examination by SAAS Automotive Pty Ltd, SAAS Automotive Pty Ltd will
only repair or replace the merchandise through the original selling dealer or on a direct basis.
SAAS Automotive Pty Ltd assumes no responsibility for diagnosis, removal and/or installation
labour, loss of vehicle use, loss of time, inconvenience or any other consequential expenses. The
warranties herein are in lieu of any other expressed or implied warranties, including any implied
warranty of suitability, and any other obligation on the part of SAAS Automotive Pty Ltd, or the
selling dealer.
For further assistance email: [email protected]
-reading is constantly
bouncing around
-the vehicles computer is
adjusting the air/fuel mixtures
-no fault, this is normal operation
-cold oxygen sensor
-wait for sensor to get up to temperature
