Installation Instructions
Wiring Guide:
Typical Layout
Wiring Diagram
Wire colour
Wire Function
Wire Connection Location
White
Vehicle body
Battery 12V+
Ground 12V-
Black
Yellow
Illumination 12V+
Park light circuit (do
NOT
connect to a dimmer)
Ignition harness / Fuse box
Red
Ignition 12V+
Orange
Ignition harness / Fuse box
Mounting studs for U bracket.
Fitting U bracket
: Fit supplied stud
spacers to threads before using the
supplied U bracket.
Programming
switch
Battery 12V+
Ground 12V-
Ignition 12V+
Illumination 12V+
VSS signal input
Connector pinout
Rear of gauge
SAAS Automotive PTY LTD
25 Metrolink Circuit West, Campbellfield,
Victoria 3061 Australia
ABN: 48166279670
ACN: 166279670
Phone: +61 3 9930 0100
Fax: +61 3 8339 2270
Email: [email protected]
Web: www.shopsaas.com
SINCE 1954
SINCE 1954
Page 1/4
Warranty Terms & Conditions:
SAAS Automotive Pty Ltd warrants this product against defects in factory workmanship and materials for a
period of twelve (
12
) months from the date of original purchase. This warranty applies to the first retail
purchaser, is non-transferable and covers only where the product has been subjected to normal use or
service. Provision of this warranty shall not apply to any SAAS Automotive product that has been used for a
purpose for which it is not designed, or which has been altered in any way that would be detrimental to the
performance or life of the product, or misapplication, misuse, negligence or accident. Warranty claims to the
manufacturer must be transportation prepaid and accompanied with dated proof of purchase. On any part or
product found to be defective after examination by SAAS Automotive Pty Ltd, SAAS Automotive Pty Ltd will
only repair or replace the merchandise through the original selling dealer or on a direct basis. SAAS
Automotive Pty Ltd assumes no responsibility for diagnosis, removal and/or installation labour, loss of vehicle
use, loss of time, inconvenience or any other consequential expenses. The warranties herein are in lieu of any
other expressed or implied warranties, including any implied warranty of suitability, and any other obligation
on the part of SAAS Automotive Pty Ltd, or the selling dealer.
For further assistance email: [email protected]
Contents:
In The Box
Qty
Speedometer gauge
Wiring connector
Mounting U bracket
Mounting U bracket studs (M4x0.7 thread)
Mounting U bracket nuts
Fitting instructions
1
1
2
2
Notes
1
Part No.
1
Programming switch
1
v20220531
Not used
Part No. SG41263
Specifications
GAUGE INFORMATION
Gauge operating range
Gauge lighting type
Gauge lighting colours
Gauge operating voltage
10v > 15v
Mounting depth required for gauge
55mm (minimum)
Mounting hole size for gauge
80mm / 3 1/4”
Gauge dimensions
88mm x 70mm
Programming switch cable length
1.1mt
Wiring harness length
2mt
red - green - blue - purple - white - amber - pink -
ice blue - orange - aqua - OFF - cycle mode
10 colour LED with 5 levels of brightness
IN-DASH SPEEDOMETER (90mm)
VSS input
Dash cluster/ gearbox / PCM module
0 > 220 km/h
Speed unit type
KM/H > MPH
Recommended signal locations
Dash cluster, ECU VSS output, SAAS GPS sensor: SG31650
Important notes before installing:
-
Installing this product to your vehicle may require an adaptor. SAAS make a large range of
adaptors and installation parts, please check with your SAAS dealer for available adaptors.
-
This product is designed for
12volt
systems
ONLY!
-
All installation work should be done by a qualified professional to avoid damage to this product.
-
SAAS
RECOMMENDS
all products be tested prior to installation. This will save time and speed up
the troubleshooting process if you encounter any issues.
- BEFORE
installing, please check our website (
shopsaas.com
) for the latest fitting instructions.
If the top left corner (
v
) number is different to website, please use instructions from website.
SG31015
SG4163
SG4106
Page 4/4
