40 32 025 940
Saab 9-3
30 Lift up the bumper shell and thread the wiring
harness through the hole under the left-hand
rear lamp cluster. Fit the grommet.
31 Fit in the two tabs of the bumper shell under the
holders and the outer corners between the wing
liner and the mounting points at the wheel hous-
ings. Press the bumper shell into place.
32 Connect the wiring harness for the bumper to
the kit's wiring harness. Fit the connector into
the hole beside the left-hand rear lamp cluster.
Fasten the wiring harness for the distance sen-
sors with a cable tie.
33
M04-07:
Fit the bolts for the bumper shell which
are located under the rear lamp clusters.
34 Fit and connect the rear lamp clusters. Check
the fit against the boot lid moulding.
WARNING
Check that the wiring harness is not pinched.
Incorrect fitting can damage the wiring harness
and cause a short-circuit/fire.
F930A660
33
34
31
34
30
32
