Saab 2005 9-7X, Руководство пользователя

Страница: 85 / 398

To program the new key, do the following:
1. Verify that the new key has PK3 stamped on it.
2. Insert the current driver’s key in the ignition
and start the engine. If the engine will not start,
see your dealer for service.
3. After the engine has started, turn the key to OFF,
and remove the key.
4. Insert the key to be programmed and turn it to ON
within 10 seconds of removing the previous key.
5. The SECURITY light will turn off once the key has
been programmed. It may not be apparent that the
SECURITY light went on due to how quickly the
key is programmed.
6. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you are ever driving and the SECURITY light comes on
and stays on, you will be able to restart your engine if you
turn it off. Your PASS-Key
®
III system, however, is not
working properly and must be serviced by your dealer.
Your vehicle is not protected by the PASS-Key
®
III
system at this time.
If you lose or damage a PASS-Key
®
III key, see your
dealer to have a new key made.
Starting and Operating Your
Vehicle
New Vehicle Break-In
Notice: Your vehicle does not need an elaborate
break-in. But it will perform better in the long run
if you follow these guidelines:
•
Keep your speed at 55 mph (88 km/h) or less for
the first 500 miles (805 km).
•
Do not drive at any one speed, fast or slow,
for the first 500 miles (805 km). Do not make
full-throttle starts.
•
Avoid making hard stops for the first 200 miles
(322 km) or so. During this time your new brake
linings are not yet broken in. Hard stops with new
linings can mean premature wear and earlier
replacement. Follow this breaking-in guideline
every time you get new brake linings.
•
Do not tow a trailer during break-in. See Towing a
Trailer on page 4-35 for more information.
2-19
2005 - Saab 97X Owner Manual