background image

 

 

set up

 

SA talent and SA exact are multipurpose speakers. They are suitable for stereo systems with or without subwoofer. In a home cinema, 
they can be used either as centre, front or rear speaker. 
The speakers are specially designed for best performance on a wall or large flat horizontal surfaces such as a shelf, a table, a 
bookshelf, or similar. 
 
Please note that: 

 

SA talent and SA exact are acoustically optimised for wall mounting or similar and will not have sufficient bass if suspended freely in 
the room. It is important for the sound quality that there is a large surface close to the speakers (within 10 cm) 

 

if SA talent or SA exact are placed on a smooth underlay, the accompanying rubber feet should be positioned on the bottom of the 
cabinets as there own vibration may cause the speakers to move 

 

if the speaker is wall mounted, the rubber feet should be attached to the back of the cabinet to avoid vibration between speaker and 
wall 

 

if the SA exact is to be mounted on a wall use at least 2 screws! Turn the brackets on the rear of the speaker, so the keyholes are 
facing the right direction. Simply unscrew the 4 small screws on the rear, turn the brackets and mount again with the screws.  

 

the better system, the better the loudspeaker will sound 

 

good cables improve the sound 

 

never turn up the volume to a level where the sound is no longer good 

 

remove the front grille for the best possible sound 

 

see www.system-audio.com for good advice and ideas  

 

opstilling 
SA talent og SA exact har mange anvendelsesmuligheder. De er velegnede til stereo, både med og uden subwoofer. I en 
hjemmebiograf kan de benyttes enten som center-, front- eller baghøjttaler. 
Højttalerne er optimerede til placering på en væg eller større vandrette flader, såsom en hylde, et bord, en bogreol eller lignende. 
 
Vær opmærksom på: 

 

SA talent og SA exact er akustisk optimerede til bl.a. vægophæng, og vil ikke gengive tilstrækkelig bas hvis de placeres frit i lokalet. 
Det er vigtigt for lydkvaliteten, at der befinder sig en større flade i højttalernes nærhed (indenfor 10 cm) 

 

hvis SA talent eller SA exact stilles på et glat underlag bør de medfølgende gummifødder placeres på undersiden af kabinettet, da 
vibrationer fra højttaleren kan forårsage at højttaleren bevæger sig 

 

hænges højttaleren på en væg, bør gummifødderne placeres på bagsiden af kabinettet for at undgå at der opstår vibrationer 
mellem højttaler og væg 

 

når SA exact ophænges på en væg, er det vigtigt at montere den på min. 2 skruer! Drej evt. nøglehulsbeslagene på højttalerens 
bagside, så hullerne vender med den smalle del opad. Udtag de 4 små skruer, drej beslaget og monter igen med skruerne. 

 

jo bedre dit anlæg er, desto bedre lyder højttaleren 

 

gode kabler forbedrer lyden 

 

spil aldrig højere end det stadig lyder godt 

 

afmonter stoframmen, når du vil have bedst mulig lyd 

 

få gode råd og ideer på www.system-audio.com 

 
connection 
the stereo’s amplifier/receiver should be turned off before the speaker is connected 
 

tilslutning 
Inden tilslutning skal anlæggets forstærker/receiver være slukket 

 
  

 
 
 
 
 
 
 
 
 

 
connection – double check 
Check that the cables are properly attached. Be extremely careful that the phase is correct on the speaker connections. This means 
that cables attached to plus (+) or minus (-) on the amplifier/receiver, must also be attached to plus (+) or minus (-) on the speakers. On 
SA speakers, the positive pole is indicated by a red socket. 
Follow the speaker cables to make sure that the right and left channels (and the centre and rear channels where appropriate) are 
attached correctly. 
 

tilslutning – dobbelt tjek 
Kontroller at kablerne er rigtigt monteret. Vær meget opmærksom på, at fasen er korrekt på højttalertilslutningerne. Det betyder at 
kabler, der er forbundet til plus (+) eller minus (-) på anlæggets forstærker/receiver, også skal forbindes til plus (+) eller minus (-) på den 
tilhørende højttaler. På SA højttalere er den positive pol mærket med rød bøsning. 
Følg højttalerkablerne for at sikre at højre og venstre kanal (og eventuelt centerkanal og bagkanaler) er forbundet korrekt.  

right speaker 

højre højttaler 

left speaker 

venstre 

højttaler 

amplifier/receiver 

forstærker/receiver  

left and right output 

venstre og højre udgang 

Отзывы: