7
2.5)
Insert the backstroke handles into the pockets shown, rounded edges toward the outside of the
block. Align the holes as shown in detail in Figure 10.
2.6)
Insert the frame support into the frame top as shown, with the large number toward the back edge
and the small number toward the short edge. Refer to Figure 11.
Figure 10
Figure 11
2.7)
Insert both pieces into the left frame as shown in Figure 12.
2.8)
Nest the right side on top and use a dead blow hammer or long clamp as necessary to ensure the
frame is tightly assembled. Rotate the shaft cover so the right frame is seated as shown in detail in
Figure 14.
Figure 12
Figure 13
Figure 14
