S-5-R465 Mini Installation Instructions
To Install the S-5-R465 Mini
1. Partially thread the setscrews into the clamp by hand.
2. Position the clamp at desired location along the seam with the bolt hole
in the correct (upslope or downslope) orientation.
3. Use a screw gun* and the included bit tip to tighten one setscrew until
flush with the seam wall. Then tighten the other setscrew until flush with
the seam wall.
4. Finally, tension and re-tension both setscrews as the seam material
compresses, i.e. tighten the first setscrew, then the second; then repeat
until each setscrew achieves the recommended torque. Screw tension
should be verified using a calibrated torque wrench as indicated below to
ensure the tool is consistently achieving the proper torque range.
S-5!® Warning! Please use this product responsibly!
Products are protected by multiple U.S. and foreign patents. Visit the website at www.S-5.com for complete information on patents and trademarks. For maximum holding strength,
inch pounds when used on 22ga steel, and between 130 and 150 inch pounds for all other metals and thinner gauges of steel. Consult the S-5! website at www.S-5.com for published data
regarding holding strength.
Copyright 2014, Metal Roof Innovations, Ltd. S-5! products are patent protected.
S-5! aggressively protects its patents, trademarks, and copyrights. Version 111814.
For critical attachment applications, tighten the included M8-1.25 X 16 mm
Hex Flange Bolt to 160 inch pounds (13 foot pounds).
Specified Torque
Inch Pounds
Foot Pounds
Nm
22ga steel
160–180
13–15
18–20
24ga steel and
all other metals
130–150
11–12.5
15–17
Once installed correctly, these clamps require no maintenance or re-
inspection for the life of the roof.
For time-saving tool recommendations, call S-5!
*
1
2
3
4
R465-V1.0-0915
setscrews should be tensioned and re-tensioned as the seam material compresses. Clamp setscrew tension should be verified using a calibrated torque wrench between 160 and 180
